User Manual
11
INSTALLATION INSTRUCTIONS
BEFORE USE
Remove all packages, including the foam backing at the bottom of refrigerator and the tapes xing
accessories in the box. Place the refrigerator to a proper position, and adjust the feet to level. It is
better to clean the refrigerator before use.
Remove the lm: There is a layer of transparent lm on the side of our product, which can protect
the appliance from being scratched in the process of production and transportation, and you can
choose to reserve or remove the lm as needed.
Place the refrigerator and adjust to level, clean it, let the refrigerator stand for above 2 ~ 6 hours to
let the compressor gas settle. Power on to ensure that the refrigerator can operate normally
TRANSPORT
Do not carry the refrigerator by holding the door or handle; the refrigerator should be carried by
lifting the bottom.
LOCATION REQUIREMENTS
WARNING
• Explosion and Fire Hazard.
• Keep ammable materials and vapors, such as gasoline, away from appliance. Failure to do so
can result in death, explosion of re.
• To ensure your refrigerator works at optimum efciency, you should install it in a location where
there is proper air circulation, and electrical connections.
• Avoid contact with strong oxidizing agents, corrosive gases and uids.
PROHIBIT
• Do not install the refrigerator where the temperature will go below 60°(16°) or above 100°(37°),
because it will not perform properly.
• Do not install the refrigerator in a location exposed to water(rain, a bath, shower, swimming
pool, wet environment, etc.).
• Do not install your refrigerator in any location not properly insulated or heated, e.g. garage, etc.
Keep out of direct sunlight and away from heating sources such as radiators, heaters, and cook-
ing appliances.
CONNECTING ELECTRICITY
WARNING
Electrical Shock Hazard
• Plug into a grounded 3-prong outlet. The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard 3-prong (grounding) wall outlet to min-
imize the possibility of electric shock hazard from this appliance.
• Have the wall outlet and circuit checked by a qualied electrician to make sure the outlet is
properly grounded.
• The refrigerator should always be plugged into its own individual electrical outlet which has a
voltage rating that matches the rating plate.
• A115 Volt AC, 60 Hz, 15- or 20-amp fused, grounded electrical supply is required. This provides
the best performance and also prevents overloading house wiring circuits which could cause a
re hazard from overheated wires.
• Never unplug your refrigerator by pulling on the power cord. Always grip plug rmly and pull