Unirac Flat Flashing INSTALLATION MANUAL © 2011 by Unirac, Inc. All rights reserved.
IMPORTANT! Unirac Inc. makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Unirac Inc. Marketing Department 1411 Broadway Boulevard, NE Albuquerque, NM 87102-1545 The information in this document is subject to change without notice. © Unirac Inc., 2011. All rights reserved.
INSTALLING UNIRAC FLAT FLASHING ON COMPOSITION SHINGLE ROOFING Step 1: Locate the rafters and snap horizontal and vertical lines to mark the installation position for each Flat Flashing. Step 2: Center the Flat Flashing over the rafter and drill a pilot hole for the lag bolt. Step 3: Insert the Flat Flashing so the top part is under the next row of shingles and the hole lines up with the pilot hole.
Step 4: Insert the lag bolt through the components in the order shown in the illustration. Tighten into the rafter. 1 1. Lag Bolt (Installer Provided) 2. EPDM Washer 2 3 4 3. L-Foot (or other rail attachment piece) 4.
WARRANTY See http://www.unirac.com for current warranty documents and information.
Unirac Flat Flashing INSTALLATION MANUAL www.unirac.
