Install Manual

UniRac Installation Manual Series

PUB 180119

JAN 2018

l rights reserved.

See www.unirac.com/distributors for your nearest Unirac distributor.

Unirac Installation Manual

StandoffsInstallation Manual

[1] Installer responsibility

The installer is solely responsible for:

• Complyingwithallapplicablelocalornational

building codes, including any that may

supercede this manual;

• EnsuringthatUniracandotherproductsare

appropriate for the particular installation and

the installation environment;

• Ensuringthattheroof,itsrafters,connections,

and other structural support members can

support the array under building live load

conditions;

• UsingonlyUniracpartsandinstaller-supplied

parts as speciﬁed by Unirac (substitution of

parts may void the warranty);

• Maintainingthewaterproofintegrityofthe

roof; and

• Ensuringsafeinstallationofallelectrical

aspects of the PV array.

PAGE 1
[1] Installer responsibility The installer is solely responsible for: • Complying with all applicable local or national building codes, including any that may supercede this manual; • Ensuring that Unirac and other products are appropriate for the particular installation and the installation environment; • Ensuring that the roof, its rafters, connections, and other structural support members can support the array under building live load conditions; • Using only Unirac parts and installer-supplied parts as
PAGE 2
R Standoffs & Flashings A HILTI GROUP COMPANY Standoffs: 3-, 4-, 6-, and 7-inch lengths available Shaft O.D. 15/8˝ Flat top 2-piece aluminum Use Use with SunFrame, SolarMount Standard, SolarMount Light, or SolarMount HD rails. Secure to rafter with 2 lag screws (sold separately). Secure L-foot or installer-supplied strut directly to standoff with standoff hardware.
PAGE 3
Standoffs & Flashings Installation Manual R A HILTI GROUP COMPANY Planning and installation There are many possible configurations of standoffs and flashing. The two examples here illustrate major product varieties and installation settings. Example 1 2-piece, aluminum, flat top standoff Soft aluminum flashing Tile roof SunFrame (shown) or SolarMount rail SunFrame rail Tile L-foot Mold flashing to tile Rafter Remove a tile over a rafter.
PAGE 4
R Standoffs & Flashings A HILTI GROUP COMPANY Warranty Information See http://www.unirac.com for current warranty documents and information.