SFM Infinity Installation Guide

SFM
SUN
FRAME
MICRORAIL™
INSTALLATION GUIDE
PAGE
TRIMRAIL + MICRORAIL INSTALLATION
I
ATTACH TRIMRAIL TO ROOF ATTACHMENT:
Attach rail using 3/8" hex bolt & Tri-drive or
serrated ange nuts. Make sure Trimrail
TM
is
level across all Trimrail
TM
roof attachments.
After rail is level, tighten channel clamp
bolts to secure Trimrail
TM
roof attachments
to channels.
POSITION MODULE CLIPS ACCORDING TO
MODULE THICKNESS:
Align notch in module clip with trimrail rib
according to module thickness (identied in
mm on faces of module clips). Rotate clip to
position at required location.
INSTALL MODULE CLIPS ON TRIMRAIL:
Attach module clips to Trimrail using 3/8"
T-bolts and Tri-drive or serrated ange nuts. A
minimum of two clips are required per module.
Refer to SFM D&E guide and U-builder for
required position and quantity of module clips.
INSTALL MICRORAILS:
Install Microrail
TM
at marked attachment points. Click
Microrail
TM
into sliders and push Microrail
TM
to top of slider.
Ensure that cap remains in upper most (40mm) position.
NOTE: module clips may be pre-installed on trimrail
prior to attaching trimrail to roof attachments
NOTE: Bonding pin on Microrails should be positioned downslope.

BONDING PIN




