SFM Infinity Installation Guide

SFM
SUN
FRAME
MICRORAIL™
INSTALLATION GUIDE
PAGE
MODULE MOUNTING
J
SEAT MODULE(S):
Ensure that modules are properly seated
in cap and base.
LAY IN MODULE(S):
Install rst two (2) modules on bottom row.
Install downhill end of module into the Trimrail
TM
and module clips rst and then position uphill 2"
microrails to support modules.
ADJUST MICRORAIL CAP DOWN TO ENGAGE WITH MODULE:
With microrail pressed against module 1. Apply downward
pressure to module side of cap which will 2. separate
cap from base on capture side and allow cap to 3. contact
module and 4. simultaneously re-engage to base at
corresponding module height location.
VERIFY CORRECT POSITION OF CAP:
Check position and verify cap on down-slope side is tight
with no gap between cap and module after tightening bolt
LAY IN MODULE(S):
Module should slide into catch features
of the Trimrail
TM
and module clips.



40 mm
 




38 mm
35 mm
33 and 32 mm