SFM Infinity Installation Guide

SFM
SUN
FRAME
MICRORAIL™
INSTALLATION GUIDE
PAGE
MODULE MOUNTING
K
FASTEN MODULES:
Finish installing modules along row and tighten
fastening bolts on microrails and splices to 20 ft.
lbs after entire row is installed.
ATTACHED SPLICE ADJUSTMENT:
Tower and height adjustment feature may be
located to alternate position as required to achieve
minimum module engagement.
ATTACH SPLICE:
Attach splice at intersection of two (2) modules.
• Use attached splice if required per SFM D&E
Guide.
• Ensure minimum module engagement using
indicator marks.
TIGHTEN FASTENERS:
Tighten fasteners to 20 ft lbs.
NOTE: Tighten components in following order:
 Module clamp socket head cap screw then
 Dovetail socket head cap screw
Wire management is performed after each row of modules is installed. Refer to wire management section (pp. L & M) for detailed instructions.







1. With 1/4" hex drive tool, rotate height adjustment
feature clockwise until head clears thru-hole in
base. 2. slide tower to alternate position and align.
height adjustment feature head with clearance
hole. 3. Rotate height adjustment feature counter-
clockwise until head enters clearance hole.