User's Manual

4.We will complete the power calibration by adjusting the resistance.
step 1.Turn the adjusting screw to ensure that the tire and the roller just touch, this is
"0 resistance"
step2. After reaching "0 resistance", We suggest you make the tires fully stressed by
turning the adjusting knob for 0-3 laps. The greater the number of turns, the greater
the resistance.
step3. Enter the number of laps in the Onelap Utility APP
►Device connection instructions
Indicator Light Status
Flashing Green Light
Speed data is being broadcast over
bluetooth.*
Flashing Red Light
Cadence data is being broadcast over
bluetooth.*
Alternatively Flashing Red
& Green
Device Battery Low*
1.The pod will only start sending Bluetooth broadcasts after it is properly installed
and woken-up. Then, you can use the corresponding device or APP to search and
connect.