Specifications

EFP9800 ESC/POS Commands
6– 46 3255 4073– 002
Transmit Paper Sensor Status
Transmits the status of a paper sensor.
Hexadecimal Decimal ASCII
1B 76 27 118 ESC v
Receipt/Journal Paper Out Switch Status
Bit Receipt/Journal Paper Out Switch
Sensor
0 1
0 Receipt/Journal Paper Near End Paper Low Not Detected Paper Low Detected
1 Receipt/Journal Paper Near End Paper Low Not Detected Paper Low Detected
2-3 Undefined
4 Not Used Always 0
5 Slip/Validation Slip Present Slip Not Present
6 Slip/Validation Slip Present Slip Not Present
7 Not Used Always 0
Note: Slip status may not be accurate for paper with holes.
When this command is performed during printing, status is transmitted after the
current line is printed and fed. (This timing differs from that for the Transmit
Peripheral Device Status, Transmit Printer ID, and Transmit Printer Status
commands.)
When DTR/DSR control is selected, the printer confirms that the host computer
is ready to receive data (DSR signal is SPACE) and then transmits only one
byte. If the host computer is not ready to receive data (DSR signal is MARK),
the printer waits until the host computer is ready.
When XON/XOFF control is selected, the printer transmits only 1 byte before
checking the DSR signal.
Because status is transmitted when this command is buffered, there may be a
lag between command reception and status transmission, depending on the
receive buffer state.