User's Manual

Figure 5

Close the battery cover. Make sure the gasket (around the battery compartment) is

properly seated in its place prior to closing the door. Tighten the set screw.

Note: Do not install the batteries backwards. You can permanently damage the sensors.

The solar panel does not charge the batteries, so rechargeable batteries are not needed or

recommended.

Note: We recommend installing Lithium AA batteries for sensors.

The sensor LED indicator will light for 3 seconds, and then flash once per 16 seconds

thereafter. Each time it flashes, the sensor is transmitting data.

Place the battery cover and push it to close the compartment.

Note: If the sensor does not power up after inserting the batteries, press the reset button

shown in Figure 6.