User's Manual

2. Rain Gauge Transmitter Installation. Remove the rain gauge funnel from the base prior to installation
by rotating the counter clockwise until the tabs on the base and the funnel align, then pulling upwards.
Fasten the rain gauge to the mounting pole, as shown in Figure 17
Tighten the rain gauge to your mounting pole or bracket with two U-bolts and four M5 nuts , or fix on a horizontal
surface with the four tapping screws, as shown in Figure 18
Reattach the funnel by aligning the tabs on the funnel and base, and rotate clockwise. Put the filter net into the top
hole to clear the debris.
Figure 16
Figure 17