User's Manual
5. Change Month. Press the SET key again to set the calendar month. Press the [+] key or [-] key to adjust the
calendar month.
6. Change Day. Press the SET key again to set the calendar day. Press the [+] key or [-] key to adjust the
calendar day.
7. Change Year. Press the SET key again to set the calendar year. Press the [+] key or [-] key to adjust the
calendar year.
8. Max/Min Clearing (default: ON). Press the SET key again to set the max/min clearing mode (CLR). The
Max/Min can be programmed to clear daily (at midnight) or manually. Press the [+] key or [-] key to switch
between “Clears 24h” and Clears Manually.
9. Temperature Units of Measure (default: °C):. Press the SET key again to change the temperature units of
measure (the UNITSET icon will be displayed). Press the [+] key or [-] key to switch between °F and °C
units of measure.
10. Wind Speed Units of Measure (default: m/s). Press the SET key again to change the wind speed units of
measure . Press the [+] key or [-] key to toggle the wind speed units between m/s, km/h, mph, knots or bft.
11. Rainfall Units of Measure (default: mm). Press the SET key again to change the Rainfall units of measure.
Press [+] key or [-] key to toggle the rainfall units between mm and inch.
12. Barometric Pressure Display Units (default: hPa). Press the SET key again to change the pressure units
of measure. Press the [+] key or [-] key to toggle the pressure units between mmhg, inHg or hPa.
13. Time SYNC(default:ON).Press the SET key again to set the internet time sync. Press the [+] key or [-] key to
switch between SYNCtime ON and SYNC time OFF.
8.3ChanelSelection
Press the CHANNEL/+ button to switch the display between remote thermo-hygrometer sensors
1 through 8, and scroll mode . In scroll mode, all of the indoor and detected outdoor thermo-hygrometer
sensors will be displayed in five second intervals.
8.4SensorSearchMode
If any of the sensor communication is lost, dashes (--.-) will be displayed on the screen. To reacquire the
signal:
Press and hold the CHANNEL/+ button for 3 seconds to enter sensor search mode, press [+] key or [-] key
to toggle between CH(1 to 8), WIND(
), RAIN( ), ALL( ) and NOT( ).
1. If a specific channel is lost, press the CHANNEL/+ button to display this channel, in search mode to
select CH(1-8) and press SET or Alarm key to exit, the search icon will be displayed constantly for 3
minutes. Once the signal is reacquired, the remote search icon
will turn off, and the current values
will be displayed.
Note: In search mode, the CH(1-8) will display the current specific channel.
2. If wind or rain sensor channels are lost, in search mode to select WIND or RAIN and press SET or
Alarm key to exit, and the remote search icon
will be constantly displayed for up to 3 minutes.