User's Manual

Chapter 2

Output Data Editing

Transmit Code ID Character

A Code ID character identifies the code type of a scanned barcode. This is useful

when decoding more than one code type. In addition to any single character prefix

already selected, the Code ID character is inserted between the prefix and the

decoded symbol.

Select no Code ID character, a Symbol Code ID character, or an AIM Code ID

character.

Note: If you enable Symbol Code ID Character or AIM Code ID Character, and enable Transmit “No

Read” Messag, the digital scanner appends the code ID for Code 39 to the NR message.

Prefix/Suffix Values

You can append a prefix and/or one or two suffixes to scan data for use in data

editing. To set a value for a prefix or suffix, scan a four-digit number (i.e., four

barcodes) that corresponds to that value.

When using host commands to set the prefix or suffix, set the key category

parameter to 1, then set the 3-digit decimal value.

To correct an error or change a selection, scan Cancel.

Note: To use Prefix/Suffix values, first set the Scan Data Transmission Format as shown below.