User's Manual

Parameter Programming Recommendations

When setting parameters via bar code or via SSI with the permanent flag set,

the following conditions must be met:

• The system must have stable power applied to the scanner.

• The engine and host must be operating and communicating with no

interference.

• Power must be maintained for at least two seconds after sending the

command or scanning the parameter bar code.

If sending parameters upon every power up, ensure they are temporary.

Motorola does not recommend sending permanent parameters or Set Defaults

upon every power up. Motorola also recommends not using a hard power

switch on the power supply.

Failure to meet these conditions can corrupt the scan engine's memory.