User's Manual

-
34
-
Scan this symbol to set the scan engine not to beep after a good decode.
The beeper still operates during parameter menu scanning and indicates error
conditions.
Parameter Scanning
Parameter # 0xEC
To disable decoding of parameter bar codes, scan the bar code below. The Set
Defaults parameter bar code can still be decoded. To enable decoding of
parameter bar codes, either scan Enable Parameter Scanning below, Set
Factory Defaults on page 29 or set this parameter to 0x01 via a serial
command.
Parameter Pass Through
Parameter # 0xF1 0x71
Enable Parameter Pass Through to transmit bar codes in the following format,
in Code 128, to the host: