User's Manual

specific range. To set lengths via serial commands, see Setting Code

Lengths Via Serial Commands on page B-6.

One Discrete Length - Select this option to decode only those codes

containing a selected length. For example, select D 2 of 5 One Discrete

Length, then scan 1, 4, to decode only D 2 of 5 symbols containing 14

characters. Numeric bar codes begin on page 77. To change the selection or

cancel an incorrect entry, scan Cancel on page 78.

Two Discrete Lengths - Select this option to decode only those codes

containing two selected lengths. For example, select D 2 of 5 Two Discrete

Lengths, then scan 0, 2, 1, 4, to decode only D 2 of 5 symbols containing 2 or

14 characters. Numeric bar codes begin on page 77. To change the selection

or cancel an incorrect entry, scan Cancel on page 78.

Length Within Range - Select this option to decode codes within a specified

range. For example, to decode D 2 of 5 symbols containing between 4 and 12

characters, first scan D 2 of 5 Length Within Range, then scan 0, 4, 1 and 2

(single digit numbers must be preceded by a leading zero). Numeric bar codes

begin on page 77. To change the selection or cancel an incorrect entry, scan

Cancel on page 78.

Any Length - Scan this option to decode D 2 of 5 symbols containing any

number of characters.

NOTE

Selecting this option may lead to misdecodes for D 2 of 5 codes.