User's Manual

Chapter 3 Getting Connected
30
2. Under Main tab, select the profile you want to
activate.
3. A pop-up window appears “A Power Cycle is
required to make settings activate properly.”
Tap OK, and then tap OK to exit the Summit
Client Utility.
4. Tap Start → Programs → Utilities → Boot-
Mode. Tap Warm Boot to warm start the ter-
minal and load the previous settings.
5. The Summit icon on the taskbar indicating the
AP is connected.
Double tap this icon to bring up Summit Con-
trol Utility. Tap Disable Radio, you can discon-
nect the AP.
Under Status tab, you can see the IP address,
signal strength and quality.