User's Manual

COMPLIANCE TO FCC US
This device complies with part 15 and part 18 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 and 18 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:· Reorient or relocate the receiving antenna.· Increase the separation between the equipment
and receiver.· Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.· Consult the dealer or an
experienced radio/TV technician for help.
FCC part 15 RF Radiation Exposure Statement:
This transmitter must not be in co-location or operating in conjunction with any other antenna or transmitter.This device complies with FCC
RFradiation exposure limits set forth for an uncontrolled environment.This device should be installed and operated with a minimum distance of 20
centimetres between the device and your body.
FCC part 18 RF Radiation Exposure Statement:
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.During the operation of device a distance of
15cm surrounding the device and 20 cm above the top surface of the device must be respected.
This device complies with Part 18 of the FCC Rules.This enquipment generates uses and can radiated radio frequency energy and,if not installed and
used in accordance with the instructions ,may cause harmful interference to radio communications,if this enquipmernt does cause harmful interference
to radio or television reception ,which can be determined by turning thr equipment off and on,the user is encouraged to try to corrected the interference
by one or more of the following measure
1) Increase the separation between the equipment and any other radio device.
2)Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.