User guide

Unitech Electronics Co., Ltd Created
by Yukiko
CE5.0 Utility
Manual
V2.0 Page 37 of 131
27. Select “Set To Factory Default”. Tap ．The scanner setting will be reset to
the original setting.
28.Under tab, select “Tools”Æ“Enable Scan”. Press scan key to scan
the barcode. Barcode data is scanned and displayed.
29. Select “AutoScan” , select “Start AutoScan”. (Default: 3 secs). Laser will emit in
every 3 seconds to read the barcode automatically. To stop the laser, select
“AutoScan” Æ “Stop AutoScan”.
OK
Test