User guide

Unitech Electronics Co., Ltd Created
by Yukiko
CE5.0 Utility
Manual
V2.0 Page 88 of 131
6. Double tap “Aimer mode”. A pull down menu show “off”and
“interlaced”. User can select any aimer mode as required. When the Interlaced
bar code is scanned, the aimer and illumination LEDs are not allowed to be on at
the same time. Select Off if you do not want to use the aimer mode.
7. Double tap “Aimer Delay”. Drag to define delay time for the operator to aim the
imager before the picture is taken. During the delay time, the aiming light will appear,
but the LEDs will not turn on until the delay time is over.