User`s manual
- 80 -
- When a bar code is detected, the lighting and decoding automatically turn on
and stay on until another period of inactivity (timeout), after the timeout the
scanner starts ashing again.
Flashing
Autostand
- Autostand triggering mode switches from Level to Flashing (1D models) or
Presentation (2D models).
- At power up the scanner is in Flashing or Presentation trigger mode (no need
to activate the trigger line). You can put a bar code in front of the scanner and
it will be scanned.
- To switch to Level activate the trigger line (press the trigger). You can scan
bar codes by pulling the trigger.
- When in Level trigger mode, after a period of inactivity lasting the time
specied by the trigger timeout, the scanner switches back to Flashing mode.
Autostand
Toggle
- Aimer and decoding is on when trigger line is activated. Activating the trigger
line again turns the aimer and decoding off.
Toggle
Presentation
- At power up lighting and decoding are on.
- After a period of inactivity lasting the time specied by the trigger timeout, the
lighting turns off or is dimmed (depending on the scanner used).
- When a new bar code is presented the lighting and decoding restart and stay
on until another period inactivity.