PA500II Enterprise Mobile Computer - PA500II - Quick Reference Guide 400891G Version 1.0 Copyright 2011 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
PA500II Product Introduction & Accessory Kit After opening the box, ensure the following accessories for the PA500II are present: PA500II Terminal Power Adapter* Battery Pack Stylus with bungee lanyard USB charging cable USB docking station (optional) QRG/UM CD-ROM * The adapter’s replaceable clip plugs is available, depending on the region. If anything is missing or appears damaged, contact your dealer. Copyright 2011 Unitech Electronics Co., Ltd. All rights reserved.
PA500II Front View 1 Barcode laser scanner (optional) 2 Status indicator 3 SDIO/MMC slot 4 Power button 5 LCD touch screen 6 Keypad 7 (Reserved) 8 Left scanner trigger key 9 Cord holder PA500II Rear View 12 13 14 10 16 11 15 Copyright 2011 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
10 Speaker 11 Battery release latch 12 Reset button 13 Main battery 14 Universal connector 15 Right scanner trigger key 16 Stylus Installing the Battery WARNING! There is a risk of fire and burns if the battery pack is handled improperly. DO NOT disassemble, crush, puncture, short external contacts, or dispose the battery pack in fire or water. DO NOT attempt to open or service the battery pack. Dispose of used batteries according to the local recycling guidelines in your area.
Charging the Battery For initial use, you need to charge your device for about 16 hours. After that, you can charge it everyday to recharge the battery to full capacity. You can charge your device using the USB charging cable or the docking station. CAUTION! Operating the PA500II for the first time without the AC adapter, and without fully charging the backup battery may result in loss of data stored in RAM memory.
The connection is secure when the bottom edge of the device is aligned smoothly with the docking station, and the LED indicator on the docking station and device lights up red. LED status during charging: – Solid red: Charging – Solid green: Charging complete If the battery level becomes low, a status icon appears on the device screen indicating low or very low battery status. In both cases, perform an ActiveSync operation to back up your data, and then recharge your device as soon as possible.
The PA500II will prompt you to calibrate the unit by tapping a sequence of screen locations. Tap gently but firmly. When you have completed the 3. 4. series of taps, press the Enter button to confirm it. Set the Time Zone, Date, and Time Select your current time zone from the Time zone drop-down menu, and then tap Next. Follow all onscreen instructions to complete the set up. The setup wizard provides tips for using the pop-up menus and assign a lock password to access your device.
To remove a storage card: 1. Hold the device securely. Push the card in and release. The card pops out. 2. Remove the card from the slot. Keypads The PA500II keypad has a navigation key and six special keys to launch particular applications and display the on-screen keyboard. 5 2 7 No. 1 6 3 8 4 Button Name Description 1 ESC Press the ESC button to exit from the section you entered. 2 P1 Press P1 to enable Task Manager. 3 P2 Press P2 to enable scanner. 4 P3 Press P3 to enable Battery.