User's Manual

45
Copyright 2012 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
Configurable parameters for individual antennas are:
z Tx Physical Port indicating the physical connector (0 thru 3) to which the logical antenna is
bound for transmission of data.
z Rx Physical Port indicating the physical connector to which the logical antenna is bound for
receipt of data. This value is currently bound and must be equal to the Tx Physical Port
value.
z Maximum Dwell Time indicating the maximum number of milliseconds that may be spent on
the logical antenna during a single cycle.
z Maximum Inventory Cycles specifying the maximum number of inventory cycles that will be
spent on the logical antenna before a switch to the next one available.
z Antenna transmission Power in 1/10 dBm increments.
Note: The dwell time and inventory cycles may not both be set to a value of zero. If the user attempts to perform
such an operation, the last of the two fields to be modified will automatically have its value converted to one (1).
To change the global antenna sense threshold, click on the “Edit Threshold” button. This will
bring up the dialog box shown in the figure below.
Select Criteria Page
Antenna Sense Threshold Settings
Use the Select Criteria page to view and configure the selection criteria query settings that can
be used for any tag–protocol operations. As shown in the figure below, this page displays the
active selection criteria of the current reader.
Select Criteria View