because we care RP901 Wireless UHF RFID Pocket Reader Quick Guide For more detailed scanner setting, please go to www.ute.com to download the user manual and RFID utility. Version 2.
FCC WARNING STATEMENT WARNING AND CAUTION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
INTRODUCTION OUT OF THE BOX Function Button Trigger Button LED Indicator RP901 1 Wireles s UHF RFID Pocket Reader 2 Quick Guide Micro USB port Wireless UHF RFID Pocket Reader Quick Guide SPECIFICATIONS Frequency Standard Read Range 865 - 928 MHz (US/EU/JP/TW/CN) EPC Gen2/ ISO 18000-6C Single Tag Mode: Up to 100cm (Depends on the type of RFID tag and environment) Multiple Tag Mode: Less than 50cm (Depends on the type and quantity of RFID tag and environment) USB Charger Cable -3- Wrist Strap M
BEEPER INDICATION READING RFID TAGS Single long beep Single beep Two beeps Below figure shows the optimal orientation of reader and RFID Tag for reading. Power up Good read i. Wireless connection ii. The reader successfully enters or exits configuration mode Three beeps Wireless disconnection Three short beeps The reader reads a tag while disconnected.
POWER UP SHUT DOWN Press the Trigger Button for 2 seconds. The unit will emit one (1) long beep and light the LED red as confirmation that the reader has successfully powered up. METHOD 1: By default, the unit shuts down automatically after 5 minutes of inactivity. METHOD 2: Using a needle or paper clip, press the Reset Button located at the bottom of the reader once. This will force a shut down.
GETTING CONNECTED Connecting to a PC/ Notebook Connecting to an Apple iOS Device 1. Press and hold the Trigger Button for 2 seconds to power up the unit, after which the blue indicator LED will flash continuously. 1. Press and hold the Trigger Button for 2 seconds to power up the unit, after which the blue indicator LED will flash continuously. 2. Long press on the Function Button for 5 seconds without releasing 2. Long press on the Function Button for 5 seconds without releasing until 3 beeps.
GETTING CONNECTED Connecting to an Android Device 1. Press and hold the Trigger Button for 2 seconds to power up the unit, after which the blue indicator LED will flash continuously. 7. If a virtual keyboard is required, please do the following: (1) Enter “Settings” (2) Enter ”Language & Input” 2. Long press on the Function Button for 5 seconds without releasing (3) Tap on “Default keyboard” until 3 beeps. This ensures the previous pairing record is deleted.
DEFAULT RFID SETTINGS Operation Mode = Trigger Mode Read Mode = Single-Tag Read Session = S0 Target = Single Target Tag Info = EPC Code and TID CRC Value = Disable Scan Period and Delay Time Scan Period = Disable Delay Time = Disable Scheme and Filter EPC Scheme Tag = All Accepted Filter = Disable Rejected Filter = Disable Affected Scheme Filter = SGTIN-96 RF Parameters RF Output Power = Level 5 (max) Data Output Format = Simple Cascade Data Content = Hexadecimal Time Log Data = Disable RSSI Data = Disable
