Quick Start Guide

Read Mode
Power Up / Shut Down
Power Up
• Short press the Power / Trigger Key to power up.
You will hear short beeps
(SPP mode: 1 beep/HID mode: 2 beeps/Buffer mode: 3 beeps)
with green flash appears on the communication LED,
then the LCD screen will appear.
Shut Down
• Long press the Select Down / Power Off button for about 3
seconds to shut down the terminal.
Start-up Screen
Note:
• The “*” indicates the default setting.
• The data will be temporarily saved in the
reader under Buffer Mode.
Reading RFID Tags
It is recommended to read RFID tags by aiming the
antenna area of RP902 at the RFID tag horizontally (as
shown in the picture below.)
Reading distance may be impacted by the type of tag
and environmental conditions.
Reading range is 1m when power is 22dBm, and the
maximum reading range is 2m when power setting is 27 dBm.
Single Read: The terminal only reads one tag upon each press.
Please release the Power/trigger key and press again to read
another tag.
The LCD screen will show the EPC code of the RFID tag being
read (shown as picture below).
Multiple Read: The terminal can read multiple tags that are
under RF coverage upon each press.
Keep pressing the Power/trigger key to read the tags that
have not been read. The tags that had been read will not be
read again, unless you release the button and press again.
When there is only one tag:
Shows the EPC Code of the tag
being read.
Multiple tags being read:
Shows the amount of tags
being read.
Operating Mode
Buffer mode
USB SPP mode
*BT SPP mode
BT HID mode
BLE HID mode
Read Mode
Multiple Read
*Single Read
Power Setting 11-27 dBm (*22 dBm)
Beep Setting
High
*Low
Medium
Mute
Vibrate Setting *Enable/Disable
Auto-Power-off
Disable
1-3/5/10 min (*2 min)
Factory Default
Enable/Disable
Setting Page
Power/
Trigger Key
Function/
Select Up Key
Select Down/
Power Off
Communication LED
Status LED
≤