Quick Start Guide

1. Short press the power/trigger key to power on RP902.

2. After powering on RP902, the communication LED

should show “flashing blue light”, it means RP902 is

waiting for Bluetooth connection.

Note: RP902 Supports NFC quick pairing.

Getting Connected

3. Enable the BT function of the host device and

select "RP902_0ABB (RP902 terminal name)" to

connect with RP902. After connection, the

communication LED should be solid blue light.

Disconnect

Long press (about 3 - 5 secs.) the two buttons at

the bottom of RP902 at the same time to release

the BT connection between the host device and

RP902.

3. Pull the battery strap upward to remove.

Remove the Battery

1. Turn the terminal to its rear side, and push the

battery lock to the right to unlock the battery.

Firmware Update

To ensure the unit working properly, please keep all

connectors away from the contaminants staying

inside of them such as dust, grease, mud, and water.

The negligence may cause the unit with no

communication, short circuited, Overheated and

so on. If the connector is damaged, please ensure

the connector is being fully repaired before using

the unit to avoid causing short circuited.

WARNING!

There is a risk of fire and burns if the battery is handled improperly.

DO NOT disassemble, crush, puncture, short external contacts,

or dispose the battery pack in fire or water.

DO NOT attempt to open or service the battery.

Dispose of used batteries according to local recycling guidelines

in your area.

CAUTION!

Unitech is a registered trademark of Unitech Electronics Co., Ltd.

Please click the URL FW Update Instructions or scan

the barcode for more information .

http://www.ute.com/

2. Grab two protrusions on two sides of battery

cover, and lift upward to remove it.