Installation Instructions

temperature measured at 2 cm from the front of the entire enclosure shall be such

that the maximum permissible temperature limit (85 °C) and the minimum

permissible temperature limit (-40 °C) shall not be exceeded under any extreme

environmental conditions.

6.4 Vibration and shock requirements

The fittings and mounting bolts used to assemble the BCM shall withstand the

maximum vibration and shock that can be generated at the installation location. The

BCM shall not be damaged by the deformation of the fitting and the damage of the

mounting screw holes. At the same time, it should be ensured that the assembly

bracket or the mounting fixing hole cannot amplify the vibration and impact of the

vehicle.

6.5 Waterproof, dustproof

In order to meet the waterproof and dustproof requirements of BCM, BCM

installation should be kept at an angle to the horizontal and vertical positions to avoid

water from the connector, the screw inflow, the connector short circuit, screw

corrosion, etc.

Z 轴：汽车的垂直方向

X、Y轴：汽车的水平方向