User's Manual

Feature Locator:
Installation Hints:
1. First use UM-4 AAA 1.5V alkaline batteries 2 into WMS-110 (Wireless Motion (PIR) Sensor)
battery holder, and check the battery positive and negative polarity marked is correct.
2. The WMS-110 (Wireless Motion (PIR) Sensor) by pressing the SET button at the side, and then
press the WR-110 (wireless repeater) at the bottom of the SET button, Wait for 30 seconds to 1
minute. If LED indicator light flash three times that means linking success. If LED indicator light
flash two times that means fail.
3. The WMS-110 (Wireless Motion (PIR) Sensor) placed on the need to detect the channel next
to，need to pay attention to the PIR sensor detector window, do not be put into place where the
sun, and not on where the ambient temperature is too high.
4. Can use the WMS-110 (Wireless Motion (PIR) Sensor) signals through the WCC-110 (Wireless
console controller), on the WPC-110 (Wireless Power Controller) do so even control. Join to link
with Gateway, please reference user manual of WCC-110 (Wireless console controller).
Troubleshooting:
1. Problem: When link with WR-110 (Wireless repeater), there is no display of LED
indicator light for WMS-110 (Wireless Motion (PIR) Sensor) to flash two or
three times.
Solution: a. Need to make sure the battery is good there is electricity, the installation of
the battery positive and negative direction is correct.
b. May be not press set button, need to link with repeater again.
c. If the above handles are invalid, please contact with agency.
2.
Problem: Unable to link with WR-110 (wireless repeater).
Solution: a. It needs to confirm the distance between WMS-110(Wireless Motion (PIR)
Sensor) and WR-110 (Wireless repeater). Wireless connects in non-camouflage
1. (SET) Setting button
2. PIR Sensor
3. Battery cover
4. Stent
5. State of LED window