Installation Manual

S Close to or in direct airflow fro m supply registers.

S In areas with poor air circulation, such as behind a door or in an alcove.

4.3.2. Remote Room Sensors

A Remote Room Sensor can be used with the Evolution Connex Control to take the

place of the control’s internal temperature sensor. This allows the Evolution Connex

Control to be mounted in areas with less than optimal airflow (such as near an

exterior door, window or in a closet). The remote sensor can be wired to the

terminal block connectors labeled S1 and S2 at the control’s backplate, or the ZS1

and ZS1C connection at the Damper Control Module. In either case, the Evolution

Connex Control will automatically detect the Remote Room Sensor and ignore its

internal temperature sensor.

NOTE: Humidity sensing will occur ONLY at the Evolution Connex Control. The

Remote Room Sensor does NOT have humidity sensing capability.

4.3.2.1. Remote Room Sensor Averaging

Typically, one remote sensor is used but, multiple sensors may be used and

averaged in some applications. Averaging requires a special series--parallel wiring

method with a specific number of sensors. See figure below. It is also important to

note the humidity sensor cannot be remotely located, so do not locate the Evolution

Contro l in an area where humidity sensing may not be accurate.