User's Manual

There are two ways to perform Installer Setup

1. Through the menus on the thermostat.

2. Using a Smart Device to setup the thermostat.

1. Installer Setup using the thermostat

TO ENTER CONFIGURATION MODE

Press and hold MENU button for approximately 5 sec.

Note: Thermostat will automatically exit this mode if no button is pressed for 3 minutes.

Pressing the DONE (Côr 5 series) or START (Côr 7 series) button will exit configuration

mode immediately.

WHILE IN CONFIGURATION MODE

Press UP/DOWN button to select which option to MODIFY. Option will flash while it is active.

(CONFIGURATION OPTIONS – DESCRIPTION SUMMARY See page xx).

 Once option is selected press NEXT to activate option values. Option values will flash

when active.

 Use UP/DOWN to change the values of the option.

 Press DONE (Côr 5 series) or START (Côr 7 series), once all necessary options have

been modified, to exit.

Note: All changes made are saved at the time of selection and will be saved in the event

of the 3 minute time-out or when installer exits from the configuration menu.

Configuring Wi-Fi from the thermostat

From the thermostat control, press START to get to the home screen on the Côr 7C.

 Select MENU

 UP/DOWN until Wi-Fi is blinking

 Press NEXT on Côr 5C or SELECT on Côr 7C

 Press UP/DOWN to until Wi-Fi Enable is blinking

o Press Next on Côr 5C or SELECT On Côr 7C

o Press UP/DOWN to change from ENABLED Or DISABLED

 Press MENU to go back.

 Continue to use up/down arrows to scroll through the options to select Wi-Fi Scan List or

manually set the Wi-Fi Name (SSID).

Note: Wi-Fi names and passwords are case sensitive. When editing names or passwords,

extra characters can be removed by replacing them with a blank space. The alpha

numeric list is in this order when pressing the UP arrow: lowercase, uppercase, blank

space, special characters then numbers when pressing the UP arrow. Order reversed when

pressing the DOWN arrow.