User's Manual

Fan button switches FAN icon between AUTO and On. While On is displayed, G output will be

energized, turning fan on. On some fan coils, fan continues to operate for 90 sec after G signal is

removed.

Final Settings

Be sure to press DONE or START to exit installer setup mode. If the system is to be left in

operation after installation is complete, use (HEAT/COOL) button to select between HEAT,

COOL, or AUTO to provide desired operation of heating, cooling, or auto. On the programmable

models, the default setpoints and programmed schedule conform to the Energy Starr

requirements of the U.S. Department of Energy for both heating and cooling. These provide

energy saving temperature settings. Refer to Table 1.

Table 1 – Energy Star Default Schedule

If the programmed schedule is to be used, make sure one of the Touch-N-Go icons is visible

without the hold button during idle mode (press start to toggle from active screen to idle screen).

Pressing the HOLD button will display the hold options and then the up/dn arrows will scroll

through options based on current selection. Touching Select will either accept the hold option or

go to the next level of options for that specific hold.

Hold options:

 Hold till next period – at the time of the next period the schedule will resume

 Hold until time (configurable) after reaching the time entered the schedule will resume

 Permeant – keeps the setpoints entered until the user makes a change

 Cancel or No Hold – The schedule will resume immediately

The FAN button on the home screen may be used to select between AUTO (fan on only with

equipment) and On (fan on continuously) fan modes. The fan can also be put into “Air

Circulation” mode by selecting Menu > Settings > up/dn arrow until you see Circulation > Select

then up/dn arrow to change minutes per hour. That will allow the user to select the number of

minutes per hour the fan will run even if there is not call for heat or cooling. If the user needs to

have different min/hr of air circulation then they program that under user schedule buy going to

home screen > Menu > Schedule > Circulation.

For further information on temperature selection and programming, refer to Homeowner’s

Guide.

Setting The Clock, Calendar and Schedule