Installation Guide

ISOCOVERS

Insulation Systems

7.31.15 1.0

HOW TO INSTALL ISOCOVERS INSULATION SYSTEMS

Installing your ISOCOVERS Insulation Jacket to your selected application is very simple and much

easier than you might think.

CliCk HERE foR vidEo tutoRial: How to install isoCovERs insulation systEms

WARNING: When installing or measuring for ISOCOVERS, please follow all safety precautions and use proper

and adequate protective safety aids such as: protective gloves and suitable protective clothing. Never

use a metal tape for measuring purposes. Failure to do so may result in injury.

TOOLS NEEDED: Wire Cutters, LaCing Wire, PLiers & safety gear

1. WRAP THE ISOCOVERS INSULATION JACKET AROUND THE

APPLICATION YOU WISH TO INSULATE AND PULL THE DRAW

CORDS TIGHT:

PAGE 1
ISOCOVERS Insulation Systems HOW TO INSTALL ISOCOVERS INSULATION SYSTEMS Installing your ISOCOVERS Insulation Jacket to your selected application is very simple and much easier than you might think. Click HERE for video tutorial: How to install ISOCOVERS Insulation Systems WARNING: When installing or measuring for ISOCOVERS, please follow all safety precautions and use proper and adequate protective safety aids such as: protective gloves and suitable protective clothing.
PAGE 2
ISOCOVERS Insulation Systems 2. TIE THE DRAW CORDS TOGETHER TO GIVE IT A SECURE FIT: (DO NOT OVER-TIGHTEN) 3. PULL OUT A SUFFICIENT AMOUNT OF SS WIRE AND TWIST THE END OF IT INTO A LOOP. TRIM THE SS WIRE AT THE BASE OF THE CYLINDER AND ATTACH IT TO AN SS LACING HOOK ON THE ISOCOVERS INSULATION JACKET: 7.31.15 1.
PAGE 3
ISOCOVERS Insulation Systems 4. SECURE THE ISOCOVERS INSULATION JACKET BY LACING THE SS WIRE BACK AND FORTH BETWEEN THE SS LACING HOOKS: 5. TRIM OFF ANY REMAINING SS WIRE USING THE WIRE-CUTTING PLIERS, ONCE YOU HAVE FINISHED LACING IT AROUND THE ISOCOVERS INSULATION JACKET. Once the ss wire has been trimmed, you are ready to start insulating! 7.31.15 1.