Datasheet

5
A
C
4
5.9
DH
II 3 GD c nA II T5 -10°C ≤ Ta ≤ 45°C
DH-500DH-200KM-032000 DH-700
IP65
-20 ÷ +80
DH-700L5
DH-700L10
DH-700M08
DH-700M12
-
-
-
-
DH-200L5
DH-200L10
DH-200M08
DH-200M12
DH-500L5
DH-500L10
DH-500M08
DH-500M12
DHF-033M08
DHF-053M08
DHF-033M12
DHF-053M12
M08
M12
ACCESSORIES
Subject to change
MAGNETIC AND ELECTRONIC SENSORS
TECNICHAL CHARACTERISTICS
Type
5÷250 V AC/DC
200
10
< 3,5
85
< 0,5
< 1
>10
7
red
2x0,25
3000
A
5÷250 V AC/DC
200
10
< 3,5
60
< 0,5
< 1
>10
7
red
2x0,25
3000
A
5÷250 V AC/DC
1000
30
< 3,5
85
< 0,5
< 1
>10
7
red
2x0,25
3000
A
10÷30 V DC
200
5
0,7
30
0,08
0,03
>10
9
red
3x0,25
3000
C
Part no.
OTHER VERSIONS AVAILABLE
With 5m cable
With 10m cable
With 0,2m cable with M08 connector 60 V
With 0,2m cable with M12 connector
3m ext. cable with M08 3-poles connect. 60 V
5m ext. cable with M08 3-poles connect. 60 V
3m ext. cable with M12 3-poles connect.
5m ext. cable with M12 3-poles connect.
ELECTRICAL CIRCUITS
AC/DC 2 wires NO
DC 3 wires PNP NO
BRN = Brown BLK = Black BLU = Blue
Magnetic and Electronic proximity sensor
Available ATEX version upon request
ELECTROMECHANICAL
REED
Working voltage (V AC/DC)
Max switching current (mA)
Max switching power (W/VA)
Max voltage drop (V AC/DC)
Minimum magnetic fi eld (gauss)
Opening response time (ms)
Closing response time (ms)
Electric life with resistive load (cycles)
State indicator (LED)
Cable number and section (mmq)
Cable length (mm)
Electric circuit
Protection degree (EN60529)
Working temperature (°C)
ELECTRONIC
PNP
When using the M08 and M12 3-poles extensions cable with DH-200 and DH-500 magnetic sensors,
exclude the blue wire before connection.
Make sure to correct polarity connection while using direct current; avoid magnetic fi elds infl uencing
the electronic sensor; install the KM-008200 protection fi lter in case of extension cables longer than
10m; install dedicated fi lters in case of inductive loads.
The extension cable may be supplied at the requested length.
For the version without LED indicator, please add suffi x “E”.
Sensors assembled on cylinders detect the position of the piston by switching an electric
signal when the magnetic field, produced by the magnet in the piston, is approching.
Available in two different types: electromechanical with Reed bulb and electronic with
magnetoresistive effect both in NO version with PNP output and NC version with NPN
output.
The Reed bulb type normally works both in direct and in alternating current while
the electronic type works in direct current only (max 30V DC).
For types and versions, see ATEX catalogue