User manual

44 Version 1.0 © UNIVERS

English

Menus and OSD

Select now the 00 Ref Position entry with the CH buttons and press OK again.

The receiver will then send a command to the engine to go to the “0 degree” position. Both

devices will be thus adjusted to each other.

Satellite name

Select, with the

VOL press buttons, the satellite you wish.

Once the satellite has been found, you can start a search run directly from this entry, by

pressing OK.

Transponder

Select a transponder with the

VOL buttons.

This option provides information on frequency, symbol rate and polarity.

Once you have found the satellite, you can start a transponder search directly from this

entry by pressing OK.

Caution: Please test the usual satellites before trying the “exotic” ones!

Positioner

Choose < On > with the

VOL buttons if you still have not done it from the Antenna

Config > Setup option.

Continuously Move

The

VOL press buttons will allow you to send commands to the engine, for it to turn

East or West. If it is a command stored in the DiSEqC engine (Example: Astra 19,2° East),

it will turn automatically by pressing

VOL until the engine achieves the stored

position.

However, if you press the

VOL button for the engine to turn West, it will turn

continuously to the west until it reaches the west limit.

Move Steps

This option makes you send the command for the engine to turn east or west in a step by

step way by pressing the

VOL buttons.

The steps width is determined under Step size.

You can adjust the step as you wish by making use of the Strength and Quality options.

Press the OK button once you have made the modifications you want.

Step Size

You can indicate here how much the engine is supposed to turn in each movement under

the Move Steps option.

Select the step width using the

VOL press buttons, from step size 1 until 10.