Installation guide

PAG.
27
English
rev 1.1
will search the selected TP. In case you select “On”, the NIT
(Network Identifi cation) will be identifi ed and the receiver will
automatically search all the TP of this network.
6. Press [OK] to start scanning.
7. On the “TP Scan” item, press [Exit] to cancel the scanning
and saving the found channels.
4.4. SATELLITE LIST
When you enter the “Satellite List” menu you can see a window
like the one beside (OSD 50):
1. Move through the satellite list using [ ] and mark/
unmark the satellites that you want pressing [OK]
2. Press [Red] button to enter edit satellite menu (OSD 51).
You can edit the satellite’s name and its longitude. Once you
have edited the satellite, select “Save” option and confi rm with
[OK]. If you prefer to exit without saving the changes select
“Exit” and press [OK].
3. Press [Green] button to open the “Add satellite” window. You
can edit the satellite’s name and its longitude. Once you have
edited the satellite, select “Save” option and confi rm with [OK].
If you prefer to exit without saving the changes select “Exit” and
press [OK].
4. After pressing [Yellow] button you will be asked “Are you
sure to delete?” (OSD 52). Select “Yes” to delete the marked
satellite. Select “No” to cancel the operation.
4.5. SATELLITE GUIDE
When you enter “Satellite Guide” menu, you will see the screen
like beside (OSD 53).
Here you can enter your local longitude and latitude and the
satellite’s longitude. The receiver calculates the antenna’s
azimuth and elevation to point your antenna to the selected
satellite.
1. Use the [Number] buttons to input the values of “Local
Longitude”, “Local Latitude” and “Satellite Longitude”.
2. Press [ ]buttons to select east or west in “Local
Longitude” and “Satellite Longitude” or to select north or south
in “Local Latitude”.
3. Highlight the “Start” item and press [OK]. In the lower part
of the window the corresponding values for the antenna setting
are displayed (OSD 54).
4. Orientation means the angle between south and satellite.
5. Press [Exit] to leave this feature
INSTALLATION
OSD 51
OSD 52
OSD 50
OSD 54
OSD 53