Installation guide

PAG.
31
English
rev 1.1
OSD 65
OSD 66
OSD 67
SYSTEM SETUP
4. When you select “Channel” (timer setting for channel change
and Wakeup/Sleep) then you have further options you need to
set (OSD 65):
- Wakeup Channel: press [OK] to enter the channel list and
select the channel you want to see.
- Wakeup Date: use number buttons to input your wakeup
date.
- On Time: use number buttons to input your wakeup time. If
date and time are reached then no matter if the system is in
standby mode or in playing mode, it will automatically switch
to the channel you set and start to play.
- Duration: Here you can set the time you want to see or play
this channel. After the time set the system will automatically
switch to standby mode. If you don’t want the box to be swit-
ched to standby mode then set the duration to 00:00.
5. When you select “Message” (reminding message) option in
“Timer Service” then you can enter additional data (OSD 66):
- Wakeup Message: press [
] to select the category of the
reminding message from Birthday, Anniversary and General.
- Wakeup Date: Use the [Number] buttons to input your
wakeup date.
- On Time: Use the [Number] buttons to input your wakeup
time. If date and time are reached, no matter if the system is in
standby mode or in playing mode, it will automatically show a
reminding message.
- The message will be displayed on the screen until you press
[Exit] to close it.
6. Press [Exit] to leave the “Timer” menu.
NOTE: If the receiver is in stand-by, and Low Power
Consumption mode is active, the receiver will switch on 1 min-
ute before the programmed event.
5.3.2. LOCAL TIME SETTING
When you select “Local Time Setting” and press [OK] then you
will see a window like the one beside (OSD 67):
1. GMT Usage: This item is used to set the time by using the
time signal from the satellite. Press [ ] to change the
setting.
2. The “GMT Offset” item is only available when “GMT Usage”
is set to “On”. Press [ ] to set the “GMT Offset” value.
With every time you press the button the time offset will be
increased / decreased by half an hour.
3. Summer: this option is only available when “USE GMT” is
enabled. Use [ ] to switch on/off the summer timetable.
4. “Date” and “Time” items are only available when the “GMT
Usage” is set to “Off”. Press [ ] to select one item and
use number buttons to input time and date directly.
NOTE: If the current channel provides the correct time
information, you will see the current time after you entered
“Time” menu. If the channel doesn’t provide time information,