Installation guide

English

PAG.

rev 1.2

2. BASIC OPERATIONS

2.0. SWITCH ON STB

Switch the [Device’s Main Power] switch on.

When the STB is ﬁ rst used it will display the quick setup page where the receiver can be conﬁ gured

quickly.

For further use the STB will play the same channel as last time when it was switched off.

? FREQUENTLY ASKED QUESTION

Q: The power of my STB is on and it is running in TV mode but the TV screen shows nothing:

A: Make sure the TV set has been set to the correct video input (not the TV channels). For example, if

you have connected the STB to the Video1 input of the TV set, then you need to select the corresponding

Input on the TV. Mostly it is done with the AV button of the TVs remote control unit.

Q: My STB is running in TV mode but the TV screen shows nothing except one ball and “No Signal”.

A: That means the channel you selected has no signal. This can be caused by several reasons:

1. The channel you selected is not from the satellite to which your dish is pointing. Select another

channel.

2. The signal of current TV channel is too weak. You can try to change to other channels with a stronger

signal. If the problems still exist, please consult your local dealer or installer for technical service.

3. You selected the wrong LNB type in the installation menu or your DiSEqC switch conﬁ guration is

not correct.

PANEL & REMOTE CONTROL DESCRIPTION

1.- POWER: Switches receiver ON or in stand-by-mode.

2.- TEXT: Opens and closes teletext.

3.- MUTE: Switches audio on and off.

4.- NUMERIC KEYS: For direct typing values and

names.

5.- “0”

6.- CH+ / CH-: Changes channel up and down.

7.- TV/R: Switches between TV and Radio channels.

8.- VOL+ / VOL-: Adjusts audio volume up and down.

9.- EXIT: Exit menus or stop operations.

10.- MENU: Opens the main menu.

11.- BACK: Watch the last viewed channel.

12.- OK: Conﬁ rms selections or opens channel list.

13.- EPG: Shows the EPG information.

14.- List: Opens channel list.

15.- Fav: Opens favourite channel list.

16.- Audio: Opens audio menu.

17.- Info: Shows channel information with signal bar.

18.- Fav+ / Fav-: Moves favourite channel up and

down.

19.- Pup / Pdw: Moves cursor in block steps

20.- Zoom: Zoom function.

21.- Sub: Switches subtitle on and off.

117