Installation guide

English
PAG.
28
rev 1.2
4.6. SATELLITE GUIDE
When you enter “Satellite Guide” menu, you will see the screen
like beside (OSD 57).
Here you can enter your local longitude and latitude and the
satellite’s longitude. The receiver calculates the antenna’s
azimuth and elevation to point your antenna to the selected
satellite.
1. Use the [Number] buttons to input the values of “Local
Longitude”, “Local Latitude” and “Satellite Longitude”.
2. Press [
]buttons to select east or west in “Local
Longitude” and “Satellite Longitude” or to select north or south
in “Local Latitude”.
3. Highlight the “Start” item and press [OK]. In the lower part
of the window the corresponding values for the antenna setting
are displayed (OSD 58).
4. Orientation means the angle between south and satellite.
5. Press [Exit] to leave this feature
4.7 UNICABLE CONFIGURATION
If you have an Unicable installation that allows you to distribute
a satellite signal through a unique cable up to 8 receivers as
maximum, in this menu option you can confi gure the receiver
(OSD 59). There are two ways of doing it:
1. Automatic Confi guration. Unicable system assigns
automatically the frequency that every receiver uses to work.
2. Manual Confi guration: Press [OK] to check the options:
- FI Channel: select with [ ] keys the numbers
from 1 to 8.
- FI Frequency: With [ ] keys choose the
frequency.
Each receiver of the Unicable system must have a channel and
frequency different from the rest.
* This receiver is not compatible with SatCr switches
OSD 57
OSD 58
OSD 55
OSD 56
OSD 59
INSTALLATION