Installation guide

English
11
OSD 25
OSD 26
OSD 27
OSD 28
When you enter to Channel Scan menu, there will display
the screen like below (OSD 25):
1. There is two mode. You can scan channel by channel or
by frequency .
2. When scan band is UHF, the range of Ch No. is from 21
to 69.
3. When you complete your modification,move highlight to
Search item and press [OK] key, then it will begin to scan.
4.In the Channel Scan item, press [Exit] key to exit the
scanning and save the current parameters.
When you enter to Channel Setup menu, there will display
the screen like below:
1. You can see the channel information like the picture
displaying (OSD 26).
2. Move the [Up/Down] key can move the highlight to select
the channel.
3. When press [OK] key again, you can see the window
like below (OSD 27):
4. Input PID information,then move highlight to Search
item and press [OK] key, then it will begin to scan.
When you enter to Aerial Adjustment menu, there will
display the screen like below (OS28): In Aerial Adjustment
mode:
1. Ch No.: Press [Left/Right] to select the
Ch No. The range is from 2 to 69.
2. Tuner Power: On / Off
4.2 CHANNEL SCAN
MENU OPERATIONS
4.3 CHANNEL SETUP
4.4 AERIAL ADJUSTAMENT