Installation guide

PAG.
12
English
1. descriPciÓn del PAneles Y mAndo A distAnciA
remote control & PAnel descriPtion
1. ANTENNA IN: Terr. input of the digital tuner.
2. LOOP OUT: Terr. ouput for cascading to others devices.
3. RS-232: Serial Port allowing software upgrades.
4. POWER ON/OFF: Allows to completely switching off the receiver.
5. S/PDIF: Coaxial output for digital audio (AC3).
6. TV SCART: Output SCART for the connection to a TV set.
7. VCR SCART: Output SCART for the connection to a VCR.
8. IN 12-24 VDC: 12-24 VDC connection (power supply).
1. POWER: Switches the receiver on, or enters standby mode. To completely switch off the receiver,
you have to use the switch on the back of the receiver.
2. POWER LED: Indicates that the mains voltage is available.
3. LOCK LED: Indicates a sufficient signal level at the IF IN input.
4. DISPLAY: 4 Digits to display the program numbers.
5. IR-SENSOR: Reception sensor for the IR remote control signals.
6. CH+/-: These buttons allow changing the current channel.
1
1
2
5
6
3
7
4
8
2 3 4 5 6