Installation guide

ManualsBrandsUnivers by FTE ManualsTV set-top boxesU4153

PAG.

English

osd 40

2.Menu Lock determining that when user wish to enter

“Installation” menu, whether have to input Password or not.

If the setting of “Menu Lock” is “Yes” which means user

have to key in password, set “No” means unlock.

3. Channel Lock determining that when user wish to play

the lock channels, whether have to input the password

or not. If the setting is “Yes”, play the channels with lock

mark will show up a dialogue on the screen and ask for

the password. If the setting of “Channel Lock ”is “No”, the

Lock function will invalid.

4. New Password is used for revising password; you can

input the new password in this item by using number keys

directly. After you filled in 4 digital numbers, the highlight

will auto skip to Confirm Password and ask you to input

the new password again. If the password is correct, the

screen will show up a message of “Change password

successfully”. After finish saving and draw back to “System

Setup” menu, the revising is complete.

5.Press [Exit] key to draw back from the “Parental Lock”

menu.

5.8. stAndBY mode

When you select this option, you will see a screen like beside

(OSD 41):

1. Low Power Consumption: At this option, you could enable

/ disable the low power consumption mode. This mode

allows saving current consumption when the receiver is

stand-by.

Low power consumption mode only can be enabled when the

VCR Loopthrought option (see point 5.2.) is STB master

selected. By the other way, if you choose VCR master,

then the Low Power Consumption option will not be active

and the receiver will not be in LPC mode.

2. Press [Exit] button to leave this menu.

5.9. rcu Position

In order to avoid interferences between remote controls,

you have the possibility to change the code of it, to do that

you have to change the position of a switch in the remote

control.

But first of all you have to change this code in the receiver.

You can do this in the menu “Position RCU”. ( OSD42)

You have to select the same position in the receiver and in

the remote control.

menu oPerAtions

osd41

imG4

osd42