User guide

The Technical Stuff
__________________________________________________________
- 18 -
Electro-Optical Compression/Limiting
In order to operate, a compressor must first have some method of determining the level of the
incoming signal, and must then be able to use the fluctuations in that signal to control the gain. There
are many different circuit designs which have been developed to accomplish these tasks. In each
channel of the 2-LA-2, both of these functions are performed by an electro-optical element called a T4.
A T4 is at the very heart of each of the dual compressors in the 2-LA-2. It is comprised of a small light-
proof metal canister that contains two components: an electro-luminescent (EL) panel (a device that
lights up when electrical signal is applied) and a cadmium-sulfide photoelectric cell (a light sensitive
device whose electrical resistance changes depending upon the intensity of light to which it is
subjected). It is the unique gain reduction characteristics that result from the interaction between
these two components that predominantly gives an electro-optical compressor its signature sound.
(Note: While the “el-op” circuit design was one of the first of its kind, and is still used to this day in
other compressor products, Universal Audio has its photo-cells uniquely manufactured to exacting
specs that were originally found on the LA-2A. No other manufacturers have access to these cells.)
The genius of the el-op circuit lies in its simplicity: the larger the signal that is applied to the EL
panel, the brighter the light that is generated; the brighter the light, the less resistance the photo-cell
(which controls the gain of the electrical circuit) exhibits. Thus, the louder the incoming signal, the
brighter the light and the more gain reduction is applied... and with virtually no harmonic distortion or
audible artifacts. (In the most extreme case, if the resistance of the photo-cell becomes zero [a dead
short], then the signal would be grounded and there would be no output. In reality, photo-cell
resistance cannot go completely to zero and hence there will always be some signal present.)
Conversely, when there is a small input signal (resulting in a dim light), the photo-cell will have a
great deal of resistance and will therefore not affect the circuit at all, so there will be no gain
reduction.
Perhaps the most important thing about electro-optical compression and limiting is that it is 100%
program-dependent; in other words, both the degree of gain reduction and the compression ratio vary
continuously with the incoming signal, making for a very natural sound. What’s more, unlike other
compressors which allow the user to adjust the attack and release times, both of these parameters are
automatic and are completely determined by the response of the EL panel and photo-cell in the T4.