Instruction Manual

Front Panel
__________________________________________________________
- 5 -
Note that the clock source can be independent of the signal used for digital to analog conversion.
For example, you could select AES/SPDIF as the clock source but perform D/A conversion on the
incoming ADAT optical signal by setting the Analog Outputs DAC Source Select knob ( see #6 on
page 7) to ADAT.
 The 2192 sample rate is always determined by the Clock and Sample Rate Select knobs
except when the clock source is set to AES/SPDIF, in which case the sample rate of the
incoming signal is automatically detected and used.
 The 2192 can be used for distribution of various clocks by connecting multiple clock
sources to the rear panel, then using the Clock knob to switch between them.