Operating instructions

38
Transcoding Using Digital Audio Clock
In this configuration, the 2192 is synchronized to the clock signal that is imbedded within the
digital audio source signal that is being transcoded.
To perform transcoding using the digital audio source clock:
1. Connect the digital output from the external digital audio source device to the desired 2192
digital input using the appropriate digital cable.
2. Connect the 2192 digital output(s) to the digital input(s) on any external device(s) that will
receive the transcoded digital audio signal using the appropriate digital cable(s).
3. Set the 2192 Clock knob to specify the digital audio source input (AES/SPDIF or ADAT). If the
Clock knob is set to AES/SPDIF, use the AES/SPDIF switch to specify AES/EBU or S/PDIF.
4. Set the 2192 Digital Outputs knob to the same digital source selected in step 3.
5. Set the digital audio source device to transmit digital audio. The source device must be set to
use its internal clock, or set to synchronize to an external clock master.
Transcoding is continuous as long as the digital audio source is transmitting.