User Manual

UAD Powered Plug-Ins - 135 - Precision Multiband
EQ Display Selection
A band can also be selected
by clicking within the area of
the band in the EQ Display.
For example, clicking within
the area shown here will se-
lect the LMF band.
Band Parameters
Because the Band Controls for each of the five bands are identical, they are
only described once.
All Button The ALL button provides a facility to link controls and copy parameter
values to all bands when adjusting the current band. Each of the Band
Controls has an ALL button. The behavior of the ALL button is the same for all
the Band Controls in all the bands (with the exception of the Type switch; see
“Type Switch” on page 136)
The ALL button can perform three functions: Relative Link, Absolute Link, and
Copy Value. Note that the ALL button cannot be automated.
Relative Link
In Relative mode, changes to a band control will change the same con-
trol in the other bands by a relative amount (i.e. the same amount), until
any single band reaches its minimum or maximum value.
Single-click the ALL button to enter Relative mode; the button background
changes to blue.
When adjusting a control in Relative mode, it may appear that the full range
of the active control is unavailable; this occurs when a different band (not the
active band) has reached the end of its range.
In Relative mode the Gain value can also be adjusted by dragging the Gain
“handle” in the EQ Display (see “EQ Display” on page 139).
Note: No change occurs to the parameter values unless the control is actually
moved. This allows you turn off relative linking without making any changes.