User Manual

UAD Powered Plug-Ins Manual - 27 - Installation
Installing the UAD Hardware
After installing the UAD Powered Plug-Ins software, install the UAD DSP
card(s). Hardware installation is the same for all platforms.
To install the UAD DSP card(s):
1. Turn off your computer.
2. Open the computer case. If necessary, refer to the computer manufacturer’s
documentation for instructions.
3. Remove the rear slot cover and screw of the lowest-numbered available ex-
pansion slot.
4. Before handling the UAD card, discharge any static electricity by touching
the outer casing of the power supply.
5. Remove the UAD card from its protective anti-static bag. Do not touch the
gold edge connector contacts.
6. Hold the card gently by the top edges, and line up its connector with the slot
inside the computer.
7. When the connector and slot are aligned, press the card into the slot with
firm, even pressure. The card should “pop” into place. The top of the slot on
the motherboard should be flush and parallel with the edge of the UAD
card.
8. Secure the card with the previously removed screw.
9. Replace the computer case
Hardware installation is now complete.
Figure 1. UAD card installation