Technical information

Apollo Software Manual Chapter 4: Console Reference 84
Cue Output Mono
This switch sums the left and right channels of the stereo cue mix bus into a monophon-
ic signal. The cue output is stereo when the switch is gray and mono when it is lit.
Note: This switch only controls the cue’s outputs. To hear the cue mix in mono
when it is routed to the monitor outputs (via the Control Room Source switches),
use the Monitor Mono switch instead.
Cue Output Menu (Apollo rack models)
This menu is used to optionally route the cue to Apollo’s available
hardware outputs. To select a hardware output pair for the stereo cue,
click NONE and select an available output pair from the drop menu.
Important: The cue output route overrides the DAW output chan-
nels assigned to the same hardware output(s). In other words, if
an output is in use by a cue output, it is no longer available to be
assigned as an output within the DAW.
Tip: To route signals to both the cue and the desired stereo output,
route to a dedicated cue bus via the Core Audio panel within the
Console Settings window, then assign the cue to the desired stereo
output via the Cue Output menu.
Cue output assignments are mutually exclusive. When a cue output
route is assigned, that output becomes unavailable for routing from
a different cue bus (cue mix buses cannot be merged to the same
outputs).
Note: If an output does not appear in the menu, the output is al-
ready in use by another input channel (Flex route), cue output, or ALT output.
Headphone Output Select (Apollo, Apollo 8, Apollo 8p)
These switches determine which Apollo headphone output the cue is
routed to. The headphone outputs are mutually exclusive (each head-
phone output can have only one source).
Cue Output menu