Technical information

Apollo Software Manual Chapter 4: Console Reference 86
Monitor Source Select
These switches select the mix bus that is sent to Apollo’s
monitor outputs. The source is selected when its switch is lit.
Monitor
When MONITOR is selected, the main monitor mix, summed
with any DAW outputs assigned monitor outputs (if applicable),
is routed to the monitor outputs.
Cue 1, 2, 3, 4 (Apollo rack models)
When a CUE is selected, that cue mix (the mix created from
cue sends in Console), summed with any DAW outputs as-
signed to the cue (if applicable), is routed to the monitor outputs.
HP, LINE 3/4 (Apollo Twin)
When HP or LINE 3/4 is selected, the respective cue mix, summed with any DAW out-
puts assigned to the respective HP or LINE 3/4 outputs (if applicable), is routed to the
monitor outputs.
CUE INACTIVE Dialog
CUE, HP, or LINE 3/4 can be selected as a monitor
source only if its respective source in the Cue Outputs
Popover is not set to MON.
Allowing those settings would be the same as simply
selecting MONITOR as the source with the monitor
source select, except that you wouldn’t be able to
determine the current route without opening the cue
outputs window.
If the CUE INACTIVE dialog appears when attempt-
ing to enable a cue as the monitor source, close the dialog then open the CUE OUTPUTS
window and switch that cue’s source from MON to the cue mix.
Monitor source select switches
with Apollo rack models (left)
and Apollo Twin (right)