Instruction Manual

DCS Remote Preamp Performance Specifications

A Mic, B Mic input type: XLR balanced, transformer-less

input impedance: 2 k ohms

peak input level: +14dBu RMS sine wave

CMR: >70dB 20Hz to 20kHz

A DI, B DI input type: TRS balanced or TS unbalanced, transformer-less

input impedance: 4 M ohms balanced, 2 M ohms unbalanced

peak input level: +24dBu RMS sine wave

CMR: >60dB 20Hz to 1kHz, >45dB 1kHz to 20kHz

Pre Outputs output type: TRS balanced or TS unbalanced, transformer-less

peak output level: +24dBu balanced, +18dBu unbalanced, RMS sine wave

(adjustable from 0dBu to +24dBu using GAIN Trim

control)

output impedance: 200 ohms balanced, 100 ohms unbalanced

A B Stereo Out output type: TRS stereo, unbalanced, *mono-summable by shorting T-S

peak output level: +6dBu/+4dBV RMS sine wave (-10dBV operating level)

output impedance: 500 ohms

throughput frequency response: 4Hz to 150kHz, +0/-3dB

Mic input noise: -130dBu EIN, 50 ohms 20Hz to 20kHz, 69 dB gain

DI input noise: -100dBu EIN, 50 ohms 20Hz to 20kHz, 42 dB gain

distortion (THD+N): 0.002%, 1kHz, 40dB gain, +14dBu out

cross-talk: -100dB any Mic, DI, Cue Mixer input to Preamp out

Audio Specifications: Cue Mixer

C IN input type: TRS x 2, balanced or unbalanced, mono on left

peak input level: H: +24dBu, L: +12dBu RMS sine wave (see CFG, pg 7)

input impedance: 20 k ohms

CUE IN input type: TRS stereo, unbalanced

peak input level: +24dBu RMS sine wave

input impedance: 20 k ohms

CUE OUT output type: TRS stereo, unbalanced, *mono-summable by shorting T-S

peak output level: +18dBu sine wave (190mW/channel into 50 ohms)

output impedance: 50 ohms

drive capability: 2 sets of 25-600 ohm phones (best if both pairs matched)

SPKR OUT output type: TRS x 2, balanced or unbalanced, *mono on left

peak output level: H: +18dBu, L: +6dBu RMS sine wave (see CFG, pg 7)

output impedance: 1k ohms balanced, 500 ohms unbalanced

TALK MIC OUT output type: TRS balanced or unbalanced

peak output level: +6dBu/+4dBV RMS sine wave (-10dBV operating level)

output impedance: 250 ohms balanced, 125 ohms unbalanced

throughput frequency response: 8Hz to 60kHz, +0/-3dB, any input to SPKR OUT

noise: L: -86dBu, H: -76dBu, 20Hz - 20kHz, SPKR OUT, CUE VOL full CW

distortion (THD+N): 0.004%, 1kHz, +14dBu output, 20Hz to 20kHz

cross-talk: -100dB any mic, DI, CUE MIXER in to CUE MIXER out

REVERB sample rate/bit depth: 48 kHz/20-bit

power usage 17 Watts, fixed voltage