Owner's manual

UAD Powered Plug-Ins Manual - 139 - Chapter 12: EMT 250 Electronic Reverberator
Program Mode Controls
The details of each unique program mode are below, followed by descrip-
tions of the global controls, which affect all program modes.
Control
Functions
Table 13 displays the parameter that each control is mapped to for each of
the EMT 250 program modes. See “Variable Control Functions” on
page 136 for details.
Program Mode The Program Mode buttons define which of the available program modes is
active. The six program modes are: Reverb (REV), Delay (DEL), Phase (PHAS),
Chorus (CHOR), Echo, and Space (SPC).
Click a Mode button to activate that program mode; the button is illuminated
for the currently active mode (only one mode can be active at a time). Each
program mode and its associated parameters are described in detail below.
Tip: See Table 13 on page 139 for a matrix of controls that are available in
each program mode.
Table 13. The variable control functions of the EMT 250
Program Mode Lever 1 Lever 2 Lever 3 Lever 4 Front/Rear
Reverb Reverb Decay LF Decay HF Decay (damping) Predelay Output Pair
Delay Coarse Delay Time Fine Delay Time Selects L/R channel
for time adjustment*
Predelay Stereo/Mono
Phase Phase (curve) (none)* (none)* Predelay Output Pair
Chorus (none)* (none)* Variation Predelay Stereo/Mono
Echo Coarse Delay Time Fine Delay Time HF Decay (damping) Predelay Input Mute
Space (none)* (none)* (none)* Predelay Output Pair
*Note: The parameter values of lever positions marked with an asterisk are not saved in sessions or presets.