Owner's manual

UAD Powered Plug-Ins Manual - 312 - Chapter 29: Ocean Way Studios
Wet Solo defaults to On, which is optimal when using Ocean Way Studios in
Reverb mode in the “traditional” reverb configuration (placed on an effect
group/bus that is configured for use with channel sends). When Ocean Way
Studios is used on a channel insert in Reverb mode, this control should be de-
activated so the Dry/Wet mix can be adjusted.
Wet Solo is fixed in the enabled position in Re-Mic mode so the original dry
signal cannot be mixed with the modeled direct signal component within the
plug-in.
This control uses a logarithmic taper to provide increased resolution when se-
lecting lower values. When the knob is in the 12 o’clock position, the value
is approximately 15%.
Note: Wet Solo is a global (per plug-in instance) control.
Master Level This fader controls the volume level at the output of the plug-in.
It has a logarithmic taper for a more musical response. The gain
range is from off to +12 dB. Gain is at unity when set to the zero
position.
Tip: To quickly return to the 0 dB (unity) position, click the MAS-
TER text label beneath the fader, or the “0” text label at the
fader’s unity gain position.